SWITCHLOCK
See Figure 4.
The switch trigger can be locked in the OFF position. This feature can be used to prevent the possibility of accidental starting when not in use. To lock switch trigger, place the direction of rotation selector in center position.
SELECTOR
REVERSE
CENTERPOSITION
(LOCK)
FORWARD
SWITCH
TRIGGER Fig. 4
REVERSIBLE
See Figure 4.
This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the ddll held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The ddlling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.
To stop, release switch trigger and allow the chuck to come to a complete stop.
KEYLESS CHUCK
See Figure 5.
Your new ddll has a keyless chuck. As the name implies, you can hand tighten or release ddUbits in the chuck jaws. Grasp and hold the collar of the chuck with one hand. Rotate the chuck body with your other hand. The anows on the chuck indicate which direction to rotate
the chuck body in order to LOCK (tighten) or UNLOCK (release) the ddll bit.
UNLOCK
(RELEASE) CHUCKBODY
DRILLBIT
LOCK CHUCK
(TIGHTEN) COLLAR
A WARNING: Do not hold chuck body with one hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your hand or your hand could slip and come in contact with rotating ddll bit. This could cause an accident resulting in serious personal injury.
WARNING: Battery tools are always in operating condition. Therefore, switch should
always be locked when not in use or canying at your side.
9