Safety Warnings and Precautions (continued)
5.Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust. Always lock up tools and keep out of reach of children.
6.Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protec- tive, electrically nonconductive clothes and nonskid footwear are recommended when working. Wear restrictive hair covering to contain long hair.
7.Use eye and ear protection. Always wear ANSI approved impact safety goggles.
8.Do not overreach. Keep proper footing and balance at all times.
9.Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There are certain applications for which this tool was designed. Do not modify this tool and do not use this tool for a purpose for which it was not intended.
10.Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.
11.Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn On and Off properly.
12.Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other parts will void the warranty.
13.Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool.
14.Use proper size and type extension cord. If an extension cord is required, it must be of the proper size and type to supply the correct current to the tool without heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the tool. This tool requires use of an extension cord of
0 to 10 amps capability (up to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size wire. If you are using the tool outdoors, use an extension cord rated for outdoor use (signified by “WA” on the jacket).
15.Take caution as some woods contain preservatives such as copper chromium arsenate (CCA) which can be toxic. When drilling these materials extra care should be taken to avoid inhalation and minimize skin contact.
16.Maintenance. For your safety, maintenance should be performed regularly by a qualified technician.
17.Read and understand all warnings and instructions provided in the instruction manual of the drill being used to power this Angle Drill attachment.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that com- mon sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, verify against the Parts List and Parts Diagram on the next page, that all parts are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
SKU 92188 | For technical questions, please call | Page 2 |