Specifications, Symbols | Makita LS1040S specification

ENGLISH (Original instructions)

SPECIFICATIONS

Model	LS1040 / LS1040S
Blade diameter	255 mm -260 mm
Hole diameter
For all countries other than European countries	25.4 mm and 25 mm
For European countries	30 mm

Max. Cutting capacities (H x W) with blade 260 mm in diameter

Bevel angle		Miter angle
Bevel angle	0°		45° (left and right)
	0°		45° (left and right)
0°	93 mm x 95 mm		93 mm x 67 mm
0°	69 mm x 135 mm		69 mm x 95 mm
	69 mm x 135 mm		69 mm x 95 mm
45° (left)	53 mm x 95 mm		49 mm x 67 mm
45° (left)	35 mm x 135 mm		35 mm x 94 mm
	35 mm x 135 mm		35 mm x 94 mm
No load speed (min-1)		4,600
Dimensions (L x W x H)			530 mm x 476 mm x 532 mm
Net weight			12.4 kg
Safety class			/II

•Due to our continuing programme of research and development, the specifications herein are subject to change without notice.

•Specifications may differ from country to country.

•Weight according to EPTA-Procedure 01/2003

END217-3

Symbols

The following show the symbols used for the equipment. Be sure that you understand their meaning before use. ･ Read instruction manual.

･ DOUBLE INSULATION

･To avoid injury from flying debris, keep

holding the saw head down, after making cuts, until the blade has come to a complete stop.

･Do not place hand or fingers close to

the blade.

･ For your safety, remove the chips, small pieces, etc. from the table top before operation.

･ Always set SUB-FENCE to left position when performing left bevel cuts. Failure to do so may cause serious injury to operator.

･ To loosen the bolt, turn it clockwise.

･ Only for EU countries

Do not dispose of electric equipment together with household waste material! In observance of European Directive 2002/96/EC on waste electric and

electronic equipment and its implementation in accordance with

national law, electric equipment that have reached the end of their life must be collected separately and returned to

an environmentally compatible recycling facility.

ENE004-1

Intended use

The tool is intended for accurate straight and miter cutting in wood. With appropriate saw blades, aluminum can also be sawed.

ENF002-1

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire.

For Model LS1040

ENF100-1

For public low-voltage distribution systems of between 220 V and 250 V.

Switching operations of electric apparatus cause voltage fluctuations. The operation of this device under unfavorable mains conditions can have adverse effects to the operation of other equipment. With a mains impedance equal or less than 0.30 Ohms it can be presumed that there will be no negative effects. The mains socket used for this device must be protected with