Related Manuals
Related Manuals
ProMix Manuals in English
Manual | Description |
|
|
312778 | ProMix 2KS Automatic System |
| Installation |
312779 | ProMix 2KS Automatic System |
| Operation |
|
|
312780 | ProMix 2KS Automatic System |
| |
|
|
3A1163 | ProMix 1KS Installation |
|
|
3A1080 | ProMix 1KS Automatic System |
| Operation |
|
|
3A1164 | ProMix 1KS |
|
|
313881 | ProMix 3KS Installation |
|
|
313885 | ProMix 3KS Automatic System |
| Operation |
|
|
313883 | ProMix 3KS |
|
|
Grounding
Your system must be grounded. See the Grounding instructions in your ProMix Installation manual.
Ground all components in your system, as explained in your ProMix Installation manual.
Ground a remote fluid regulator (used with Model 24H989 only) by connection to a properly grounded fluid hose.
Installation (Model 249849)
The intrinsically safe flow control module (FC) is required to use flow control in your system. See FIG. 1.
1.Connect a 1/4 in. (6 mm) OD air supply line to the air inlet fitting of the flow control module (FC). Con- nect the other end of this line as follows:
a.Wall Mount Systems: Connect to the air mani- fold at the rear of the wall mount fluid station.
b.RoboMix Systems: Install a 1/4 in. (6 mm) OD tube tee at the air logic inlet of the RoboMix. Connect the flow control air line to one branch of the tee and the main air line to the other branch.
2.Connect a fluid line from the proportioner to the 1/8 npt(f) fluid inlet of the flow control module (FC).
3.Connect a fluid line from the 1/8 npt(f) fluid outlet of the flow control module (FC) to the spray gun inlet.
4.See the Electrical Schematic in your ProMix instruction manual. Connect the flow control cable to the fluid station control board and to the cable con- nector on the flow control module (FC).
FC
Fluid to Flow Control Module
Fluid to Gun
Air to Flow Control 
Flow Control Cable
TI13656a
FIG. 1. 249849 Flow Control Module
2 | 3A2097B |