Setting the first switch on time
1.Set the programming selector to position A1. The setting for the first switch on time flashes.
2.Turn the setting knob
3.When the required switch on time is displayed, move the programming selector to any other position to confirm your setting.
Setting the first switch off time
1.Set the programming selector to position A2. The setting for the first switch off time flashes.
2.Turn the setting knob
3.When the required switch off time is displayed, move the programming selector to any other position to confirm your setting.
Setting the second switch on time
1.Set the programming selector to position A3. The setting for the second switch on time flashes.
2.Turn the setting knob
3.When the required switch on time is displayed, move the programming selector to any other position to confirm your setting.
Setting the second switch off time
1.Set the programming selector to position A4. The setting for the second switch off time flashes.
2.Turn the setting knob
3.When the required switch off time is displayed, move the programming selector to any other position to confirm your setting.
| The switch on and off times are interrelated. When trying to |
NOTE | set a switching time to a time after the subsequent switching |
| time, the latter time will automatically be pushed forward |
| (or backward). |
|
|
Setting the comfort temperature
1.Set the programming selector to position 
.
2.The setting for the current comfort temperature flashes.
3.Turn the setting knob
4.When the required comfort temperature is displayed, move the programming selector to any other position to confirm your setting.
Setting the energy saving temperature
1.Set the programming selector to position 
The setting for the current energy saving temperature flashes.
2.Turn the setting knob counter clockwise to decrease the temperature setting, or clockwise to increase the temperature setting.
3.When the required energy saving temperature is displayed, move the programming selector to any other position to confirm your setting.
Changing temporarily the current setpoint
1.The current setpoint can be changed temporarily when the operating mode selector is in the AUTO position and the programming selector in the RUN position.
2.Turn the setting knob slightly in either direction to display the current setpoint, then turn it
3.This setpoint will be maintained until the next switching time. When this has been activated, the hand symbol is displayed.
Changing the batteries
1.Get 2 new alkaline batteries type AA, 1.5 V.
2.Within 1 minute: Remove the battery holder, then the batteries, insert the new batteries and replace the battery holder.
3.Make certain the old batteries are disposed of properly, in compliance with environmental requirements.
Energy saving tips without sacrificing comfort
●Never allow room temperatures to exceed 21˚C
●Air out rooms for short periods of time only, but properly, with the windows wide open
CE1B3071en / 05.07.2007 | Subject to alteration | Siemens Building Technologies / HVAC Products |