Samsung user manual Refer to SPC-300 Connection and Control section

Introduction

-For multi-protocol settings, you can set the protocol (right 8-pin piano switch), baud rate, and communication mode of COAXIAL/COAXITRON/RS-485/RS-232.

s

t

ONON

1 2 1 2 3 4 5 6 7 8

TERMINATION PROTOCOL

-Use pin 1,2,3 of the Protocol setting switch to select a protocol.

-The protocol switch pin 4 sets the protocol to COAXIAL or COAXITRON.

-Use pin 5,6 of the Protocol setting switch to select a baud rate.

-The protocol switch pin 7 sets the protocol to COAXIAL (BNC communication) or RS-485 output.

-Use pin 8 of the Protocol setting switch to select RS-232 input.

❻Address Switch

-For RS-232 / RS-485 communications, you can use this switch to set the address.

ADDRESS

(X)100

1	2	3
		4
0			5
9		7	6
	8

(X)10

1	2	3
		4
0			5
9		7	6
	8

(X)1

1	2	3
		4
0			5
9		7	6
	8

-Set the address by using three switches shown above.

-From the left, the number is hundreds, tens and ones place, respectively. The effective range of valid address is between 0 and 255 (1~255 for multi- protocol).

g

❼Menu Navigation Key

Use this to navigate through the menus.

	ƒ For further details on ON/OFF setting of each switch for the applicable configuration,
NOTE	refer to SPC-300 Connection and Control section.

English 9