Radio Shack LK-1161 owner manual Installing Batteries, Using AC Power

The

￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

FCCWantsYoutoKnow

The FCC Wants You to Know	2
Connecting Power	2
Installing Batteries	2
Using AC Power	2
Connecting Headphones	2
Listening Safely	2
Connecting an External Amplifier	3
Using the Sheet Music Stand	3
A Quick Look at Your Keyboard	4
Basic Operation	5
Auto Power Off/Power On Alert	5
Playing the Prerecorded Tunes	5
Selecting/Playing Back a Specific Tune ...	5
Consecutively Playing Back All the Tunes	5
Using the Preset Tones	5
Selecting/Playing a Preset Tone	5
Layered Tones	5
Keyboard Split Tones	5
Percussion Sounds	6
Using the Preset Auto-Rhythms	6
Selecting/Playing an Auto-Rhythm	6
Using SYNCHRO	6
Using FILL-IN	6

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult your local RadioShack store or an experienced radio/TV technician for help.

If you cannot eliminate the interference, the FCC requires that you stop using your keyboard.

You must use shielded interface cables with this equipment.

Using Auto Accompaniment	6
Concert Chord	7
Standard Fingering	7
Using Lesson Mode	8
Playing the Left-Hand Part	8
Changing the Tone of a
Prerecorded Tune	9
Turning Key Lighting Off	9
Special Features	9
Changing Keys	9
Tuning the Keyboard	9
Troubleshooting	10
Care	10
Service and Repair	10
Standard Fingering Chord Charts	11
Rhythm List	14
Specifications	15

￿￿￿￿￿￿￿￿ ￿￿￿

Dispose of old batteries promptly and properly. Do not burn or bury them.

￿￿￿￿￿￿￿￿￿￿￿

Installing Batteries

•	Use only fresh batteries of the required size
	and recommended type.
•	Do not mix old and new batteries, different

￿￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿

You can power your keyboard using internal batteries or standard AC power with an optional AC adapter.

￿￿￿￿￿￿￿￿￿ ￿!￿￿￿￿￿￿￿￿

Your keyboard can use 6 AA batteries (not supplied) for power. For the best per- formance and longest life, we recommend RadioShack alkaline batteries. ￿

1.Make sure POWER/MODE is set to OFF.

2.Press the tab on the battery compartment cover on the bottom of the keyboard, then pull up the cover to remove it.

3.Place the batteries in the compartment as indicated by the polarity symbols (+ and –) marked inside.

4.Replace the cover.

When the keyboard stops operating properly, replace the batteries. ￿￿￿￿

￿￿￿￿ ￿￿￿￿￿￿￿￿￿

You can power the keyboard using a 9V, 800 mA AC adapter and a size M Adaptaplug™ adapter (neither supplied). Both are available at your local RadioShack store or online at www.radioshack.com. Connecting an AC adapter automatically disconnects any internal batteries. ￿

1.Make sure POWER/MODE is set to OFF.

2.Set the AC adapter’s voltage switch to

9V.

3.Insert the Adaptaplug adapter into the adapter’s cord so it reads – TIP.

4.Connect the AC adapter’s barrel plug to DC 9V on the back of the keyboard.

5.Plug the AC adapter’s other end into a standard AC outlet.

Always disconnect the AC adapter when you finish using the keyboard.

types of batteries (standard, alkaline, or

rechargeable), or rechargeable batteries of

￿￿￿￿￿￿￿￿￿ ￿￿￿￿"￿￿￿￿￿￿

different capacities.

• If you do not plan to use the keyboard with

batteries for a week or more, remove the

batteries. Batteries can leak chemicals that

can destroy electronic parts.

Using AC Power

You must use a Class 2 power

!	source that supplies 9V DC and
	delivers at least 800 mA. Its
center tip must be set to negative and its

To listen to your keyboard without disturbing others, you can connect an optional pair of stereo headphones with a 1/4-inch (6.35 mm) plug. RadioShack sells a wide selection of headphones. Insert the headphones’ plug into PHONES/OUTPUT on the back of the keyboard. Connecting headphones disconnects the keyboard’s built-in speakers.

•Do not listen at extremely high volume levels. Extended high-volume listening can lead to permanent hearing loss.

•Once you set the volume, do not increase it. Over time, your ears adapt to the volume level, so a volume level that does not cause discomfort might still damage your hearing.

plug must fit the keyboard'sDC 9V jack.

Using an adapter that does not meet these

specifications could damage the keyboard

or the adapter.

• Always connect the AC adapter to the

keyboard before you connect it to AC

power. When you finish, disconnect the

adapter from AC power before you

disconnect it from the keyboard.

￿￿￿￿￿￿￿￿ ￿￿￿￿￿￿￿

To protect your hearing, follow these guidelines when you use headphones.

•Set the volume to the lowest setting before you begin listening. After you begin listening, adjust the volume to a comfortable level.

2