Setup The DMC-805G Single Fiber Media Converter

Setup The DMC-805G

Single Fiber Media

Converter

As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

A.The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

B.The relative humidity should be less than 90 percent, non-condensing.

C.Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.

D.Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes on each side of the media converter or the fan exhaust port on the side or rear of the equipment.

E.The power outlet should be within 1.8 meters of the switch.

2 1

1 2

Switch 1 : On -> Forced Mode

Off -> Auto Negotiation mode

Switch 2 : On -> LLR enable

Off -> LLR disable

Switch 1	On	Fiber Forced Mode
	Off	Fiber Auto-Negotiation

Switch 2	On	LLR Enable
	Off	LLR Disable

Installing in a

Chassis

The Converter can be fit into any of the expansion slots on a special designed chassis.

Connecting the power

1.This Converter is a plug-and-play device.

2.Connect the supplied AC to DC power adaptor with a power voltage of 7.5Vdc/1.5Amp to the receptacle on the rear panel of the converter, and then attach the plug into a standard AC outlet with a voltage range from 100 to 260 Vac.

Sliding Switch

There is a sliding switch for duplex mode setting for fiber port. Refer to the table below for more details.

Unscrew and pull out the media converter board

yFirst, install the converter onto a carrier supplied with the chassis:

Step 1- Unscrew the carrier from the desired expansion slot on the chassis.

Step 2- Remove the screw on the converter as shown below.

Step 3- Fit the converter onto the carrier and use the screw to secure it.