Additional Notes on Operation

OPERATING TEMPERATURE RANGE

		INDOOR TEMP.	OUTDOOR TEMP.
	upper limit	32˚C D.B.	46˚C	D.B.
COOLING		23˚C W.B.		-

	lower limit	21˚C D.B.	21˚C	D.B.

		15˚C W.B.		-

	upper limit	27˚C D.B.	24˚C	D.B.
HEATING		-	18˚C	W.B.

	lower limit	20˚C D.B.	-8.5˚C	D.B.

		-	-9.5˚C	W.B.

D.B. = Dry-bulb W.B. = Wet-bulb

•The built-in protective device may prevent the unit from operating when used out of this range.

•Condensation may form on the air outlet if the unit operates continu- ously in the COOL or DRY mode when humid- ity is over 80 percent.

WHEN POWER FAILURE OCCURS

This air conditioner has a memory function to store settings when a power failure occurs.

After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings.

If the timers were set before a power failure, they will need to be re-set after power recovery.

PREHEATING FUNCTION

In the HEAT operation, the indoor fan may not start for two to five minutes after the unit is turned on to prevent cold air from blowing out of the unit.

DE-ICING FUNCTION

•When ice forms on the heat exchanger in the outdoor unit during the HEAT operation, an automatic de-icer provides heat for about 5 to 10 minutes to remove the ice. During de-icing, the inside and outside fans stop operating.

•After de-icing is completed, the unit automatically resumes operation in the HEAT mode.

HEATING EFFICIENCY

•The unit employs a heat pump that draws heat from the outside air and releases it into the room. The outside air temperature therefore greatly affects the heating efficiency.

•If the heating efficiency is reduced due to low outside temperatures, use an additional heater.

•It takes time to warm up and heat the entire room because of the forced air circulation system.

TIPS ON SAVING ENERGY

Below are some simple ways to save energy when you use your air conditioner.

SET THE CORRECT TEMPERATURE

•Setting the thermostat 1°C higher than the desired temperature in the COOL mode and 2°C lower in the HEAT mode will save approximately 10 percent in power consumption.

•Setting the temperature lower than necessary during cooling operation will result in increased power consumption.

BLOCK DIRECT SUNLIGHT AND PREVENT DRAFTS

•Blocking direct sunlight during cooling operation will reduce power consumption.

•Close the windows and doors during opeation.

SET PROPER AIR FLOW DIRECTION TO OBTAIN THE BEST AIR CIRCULATION

KEEP FILTER CLEAN TO ENSURE THE MOST EFFICIENT OPERATION MAKE MOST OF THE TIMER OFF FUNCTION

DISCONNECT THE POWER CORD WHEN THE UNIT IS NOT USED FOR AN EXTENDED PERIOD OF TIME

• The indoor unit still consumes a small amount of power when it is not operating.

AE-A09DJ, AY-AP09DJ specifications

The Sharp AE-A09DJ and AY-AP09DJ are advanced air conditioning systems designed for efficient climate control in residential and commercial spaces. These models embody Sharp's commitment to innovation, reliability, and energy efficiency, making them ideal choices for users looking to enhance their indoor airflow and comfort.

One of the standout features of the Sharp AE-A09DJ and AY-AP09DJ is their impressive cooling and heating capabilities. With a cooling capacity of 2.5 kW and a heating capacity of 2.8 kW, these units are well-equipped to handle varying environmental conditions, ensuring a comfortable setting throughout the year. This dual functionality allows users to enjoy the benefits of both cooling and heating without the need for separate systems.

Energy efficiency is a significant highlight of these models. They feature an Energy Efficiency Ratio (EER) that minimizes electricity consumption, making them an eco-friendly choice for those seeking to reduce their energy bills. The units are also equipped with advanced inverter technology, which continuously adjusts the compressor speed to maintain the desired temperature with minimal energy waste. This not only enhances performance but also prolongs the lifespan of the unit.

The AE-A09DJ and AY-AP09DJ come with additional features such as a user-friendly remote control, allowing for easy temperature management from anywhere in the room. The intuitive interface makes it simple for users to switch between modes, adjust fan speed, and set timers for added convenience. Additionally, the units are designed for quiet operation, ensuring that they do not disturb the peace of your living or working environment.

Sharp's incorporation of cutting-edge technologies is evident in the air purification features of these models. These units are integrated with a Plasmacluster Ion technology, which effectively reduces airborne allergens, odours, and harmful bacteria, providing a healthier indoor atmosphere. This air purification feature is particularly beneficial for individuals with allergies or respiratory issues.

In terms of design, the AE-A09DJ and AY-AP09DJ boast a sleek and modern aesthetic that can seamlessly blend into any decor. Their compact size makes them ideal for both small and large spaces without sacrificing performance.

In conclusion, the Sharp AE-A09DJ and AY-AP09DJ air conditioning systems offer a winning combination of performance, energy efficiency, advanced technology, and user convenience. With their dual cooling and heating capabilities, air purification technology, and stylish design, these models represent a comprehensive solution for achieving year-round comfort in a variety of settings.