CyberPower Systems 6 manual Installation on Citrix XenServer and VMware ESX/ESXi

Page 9

zClick the Finish button to complete the installation.

Note: If the Linux installation needs to be initiated in the terminal, use the ./ppbe210-linux-x86.sh–con 32-bit systems or use the ./ppbe210-linux-x86_64.sh-ccommand on 64-bit systems. Detailed installation steps are described in the Installation on Citrix XenServer and VMware ESX/ESXi section.

Installation on Citrix XenServer and VMware ESX/ESXi

The installer is used to install the Client and requires root permission. The installation wizard will guide users to complete the installation. Browse to the CD drive and find the installer in the /Software/Linux folder. Initiate an installation procedure by running the ./ppbe210-linux-x86.shcommand on Citrix XenServer or

running ./ppbe210-linux-x86_64.shcommand on VMware ESX/ESXi.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents PowerPanel Business Edition Installation Guide Table of Contents Introduction Hardware InstallationInstallation on Windows Install PowerPanel Business Edition SoftwarePage Installation on Linux Page Page Installation on Citrix XenServer and VMware ESX/ESXi Choose the destination location Access PowerPanel Business Edition Software Interface Manage PDUs in CenterAdd PDUs Assign PDU’s IP Address and Connected Outlet in Client Configure Power Protection for ComputersSetup Necessary Shutdown Time Configure Shutdown Action for VMware ESXiConfigure Shutdown Action for Citrix XenServer
Top Page Image Contents