Storm Window Requirements, Wood Pieces | Sharp AF-Q100RX specification

WINDOW REQUIREMENTS

•These instructions are for a standard double-hung window. You will need to modify them for other types of windows.

CAUTION: If the sill support bolts do not contact the window sill, or if you have a window without a sill, you must order accessory kit RAK87 to properly install this air conditioner.

•All supporting parts must be secured to firm wood, masonry or metal.

•The electrical outlet must be within reach of the power cord.

REMOVE THE AIR CONDITIONER FROM THE CASE

ARemove and save the 2 screws from the lower sides of the front grille.

BGrasp the lower corners of the grille while pressing in on the case sides with your finger tips. Pull out to release and lift it up.

NOTE: Do not pull the bottom edge toward you more than 3 Ǝ or you may damage the tabs of the grille.

STORM WINDOW REQUIREMENTS

A storm window frame will not allow the air conditioner to tilt toward the outside, and will keep it from draining properly. To adjust for this, attach a piece of wood to the sill.

	WOOD PIECES –
	WIDTH: 2″
	LENGTH: Long enough to fit inside the	C
	window frame.	C
	window frame.
	THICKNESS: To determine the thickness,
	place a piece of wood on the sill to make
	it 1/2″ higher than the top of the storm
	window frame or the vinyl frame.
	Attach securely with nails or screws
	provided by the installer.