HP 7 VoiceTab, 7 3G manual Removal and replacement preliminary requirements, Tools required

Page 14

4Removal and replacement preliminary requirements

Tools required

You will need the following tools to complete the removal and replacement procedures:

Magnetic screw driver

Phillips P0 screw driver

Plastic case utility tool

Torx T5 screw driver

Service considerations

The following sections include some of the considerations that you must keep in mind during disassembly and assembly procedures.

NOTE: As you remove each subassembly from the tablet, place the subassembly (and all accompanying screws) away from the work area to prevent damage.

Plastic parts

CAUTION: Using excessive force during disassembly and reassembly can damage plastic parts. Use care when handling the plastic parts. Apply pressure only at the points designated in the maintenance instructions.

Cables and connectors

CAUTION: When servicing the tablet, be sure that cables are placed in their proper locations during the reassembly process. Improper cable placement can damage the tablet.

Cables must be handled with extreme care to avoid damage. Apply only the tension required to unseat or seat the cables during removal and insertion. Handle cables by the connector whenever possible. In all cases, avoid bending, twisting, or tearing cables. Be sure that cables are routed in such a way that they cannot be caught or snagged by parts being removed or replaced. Handle flex cables with extreme care; these cables tear easily.

8

Chapter 4 Removal and replacement preliminary requirements

Image 14
Contents Page Product notice Software termsSafety warning notice Iv Safety warning notice Table of contents Page Product description Serviceability End user replaceable part Wireless networkingPower requirements Category Description NetworkingExternal component identification ComponentIllustrated parts catalog Locating the product name and serial number Speaker/Vibrator Module Kit , includes Tablet major components Component Spare part number Back cover MP rear-facing webcamera includes cableMiscellaneous parts Sequential part number listingSolid state drive Tools required Removal and replacement preliminary requirementsService considerations Grounding guidelines Electrostatic discharge damagePackaging and transporting guidelines Equipment guidelines Material Use Voltage protection levelBack cover Removal and replacement proceduresTablet component replacement procedures Description Spare part numberPage Middle frame Battery Power/volume button board Rear-facing webcamera WiFi antenna board FPC cable Page Speakers Vibrator module System board Page Front-facing webcamera Proximity/ambient light sensor board Specifications Factory data reset Updating apps, widgets, and the operating systemRequirements for specific countries and regions Power cord set requirementsRequirements for all countries Country/region Accredited agency Applicable note numberPower cord set requirements Recycling Index Tablet