HP 10 Plus - 3700nf manual Power cord set requirements, Requirements for all countries

Page 36

7 Power cord set requirements

The wide-range input feature of the tablet permits it to operate from any line voltage from 100 to 120 volts AC, or from 220 to 240 volts AC.

The 3-conductor power cord set included with the tablet meets the requirements for use in the country or region where the equipment is purchased.

Power cord sets for use in other countries and regions must meet the requirements of the country or region where the tablet is used.

Requirements for all countries

The following requirements are applicable to all countries and regions:

The length of the power cord set must be at least 1.0 m (3.3 ft) and no more than 2.0 m (6.5 ft).

All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country or region where the power cord set will be used.

The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or 250 V AC, as required by the power system of each country or region.

The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector for mating with the appliance inlet on the back of the tablet.

Requirements for specific countries and regions

Country/region

Accredited agency

Applicable note number

 

 

 

Australia

EANSW

1

 

 

 

Austria

OVE

1

 

 

 

Belgium

CEBC

1

 

 

 

Canada

CSA

2

 

 

 

Denmark

DEMKO

1

 

 

 

Finland

FIMKO

1

 

 

 

France

UTE

1

 

 

 

30

Chapter 7 Power cord set requirements

Image 36
Contents HP Slate 10 Plus Tablet Product notice Software termsSafety warning notice Iv Safety warning notice Table of contents Page Product description Power requirements Category Description PortsOperating system External component identification Component Microphone Micro USB port Rear-facing webcam Illustrated parts catalog Locating the serial number locationTablet major components Component Spare part numberSpeaker connector board for right speaker MP rear-facing webcam includes cableMiscellaneous parts Sequential part number listing Spare part number DescriptionRemoval and replacement preliminary requirements Service considerationsTools required Grounding guidelines Drive handlingRemoval and replacement preliminary requirements Packaging and transporting guidelines Equipment guidelines Material Use Voltage protection levelRemoval and replacement procedures Display panel assemblyDescription Spare part number Page Page Antenna Connector board Battery Remove the back cover see Display panel assembly onSpeaker connector boards Speaker connector board for right speaker 776018-001776017-001 Page Speakers Rear-facing webcam System board Front-facing webcam Display panel cable Page Specifications Power cord set requirements Requirements for all countriesRequirements for specific countries and regions Country/region Accredited agency Applicable note numberRequirements for specific countries and regions Recycling Index Jacks
Related manuals
Manual 2 pages 24.6 Kb