Remove the back cover:
1.Place the tablet on a flat surface, display panel side up, with the speakers and the micro USB port toward you.
2.Insert a case utility tool (1) or similar thin, plastic tool between the back cover and the display panel assembly. The first insertion point should be in the top edge of the tablet near the audio jack (2).
3.Lift the top edge of the back cover (3) until it separates from the display panel assembly.
4.Lift the left (4) and the right sides (5) of the back cover until they detach from the display panel assembly.
5.Remove the back cover (6).
Reverse this procedure to install the back cover.
Sensor module
Description | Spare part number |
|
|
Sensor module |
|
|
|
Before removing the sensor module, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 18).
HP Slate10 HD | 19 |