Installation

Hardware Installation

NOTE: Do not connect any USB devices to the hub until you have completed the installation.

1Plug the AC adapter into a wall outlet or surge protector. Plug the DC connector into the DC power jack located on the hub. down your system, and then open the case by unscrewing the screws in the back.

2Connect the HP 4 Port USB 2.0 Mini-Hub to any available USB port or hub connected to your computer.

3Windows will now detect the hub and install the required drivers. Your hub is now ready to use.

NOTE: The hub must be connected to a USB 2.0 compliant host in order to function in Hi-Speed mode (480 Mbps data rate). If the hub is connected to a USB 1.1 compliant host, it will operate only in Low Speed mode (1.5 Mbps) or Full Speed mode (12 Mbps).

- 5 -