Removing the ADF
To remove the ADF:
1Unplug the scanner’s power cord from the electrical outlet.
2Disconnect the ADF connector cable from the back of the scanner.
3Lift the ADF off the rear of the scanner. Lift firmly
using your fingers to separate the rear bracket
from the scanner. | Disconnecting the ADF | |||
Store the ADF in its | connector cable | |||
original box for protection. |
| .................................................................................................................................................................................................................................... | ||
4 Replace the scanner cover: |
| |||
|
| |||
a | Insert the mounting posts into the corresponding |
| ||
| slots at the rear of the scanner body. |
|
| |
b | Lower the scanner cover until the mounting posts |
| ||
| are seated firmly in the scanner. |
|
| |
c | Make sure both posts are in the same position. |
| ||
|
|
|
|
|
|
|
|
|
|
Replacing the scanner cover
Removing the ADF |