HP 3000 Sheet-feed manual Set up the hardware, Connect the power supply

Page 5

1.Decide what software to install.

If you will be using the scanner with document-management and scanning software that you already own, you only need to install the HP Scanjet Driver.

If you do not already have document-management and scanning software, you can use the software that is shipped with the scanner. Read the onscreen descriptions of the software during the installation to decide what software to install. (The software and the number of CDs that are shipped with the scanner might vary by country/region.)

2.Insert the HP Scanjet Software CD into the computer CD drive. Wait for the installation dialog box to appear.

3.Click Install Software, and then follow the instructions on the screen.

Set up the hardware

Complete the following tasks in order to set up the scanner hardware and prepare it for use.

Connect the power supply

The green LED on the power supply case is on when the power supply is functioning correctly.

1.Connect the power supply to the power supply cable, and then plug the power supply cable into a power outlet or a surge protector.

2.Check that the green LED on the power supply case is on.

3.If the green LED is on, plug the power supply into the back of the scanner.

Scanner setup

3

Image 5
Contents HP Scanjet Professional Getting Started Guide Trademark credits Copyright and licenseContents Install the software Scanner setupCheck the box contents Connect the power supply Set up the hardwareConnect the USB cable Test the installationScanner setup Installation troubleshooting Cleaning and maintenanceProduct care and support User GuideScanner specifications Specifications and warrantyEnvironmental specifications Hewlett-Packard limited warranty statementHP Scanjet 3000 Scanner Hewlett-Packard Development Company, L.P
Related manuals
Manual 35 pages 33.13 Kb