USING YOUR AIR CONDITIONER (Cont.)
•Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.
•Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air condi- tioner.
•The remote control has a signal range up to 20 feet.
•Make sure nothing is blocking the remote con- trol signal from being received by the air con- ditioner.
•Make sure the batteries are installed correctly and still have power.
•Cooling Mode: Use the COOL mode at Low, Me- dium, High, or Auto Fan speed when cooling is needed. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F.
•Once the temperature is set, the compressor will cycle on and off to keep the room temperature at the set temperature level. The lower the set thermostat temperature, the cooler the room will become. The higher the set thermostat temperature, the warmer the room will become.
•For Normal Cooling - Set the Mode to Cool and the Fan to High or Med with the termperature set in the middle.
•For Maximum Cooling - Set the Mode to Cool and the Fan to High with a lower set temperature.
•For Quieter & Nighttime Cooling - Set the Mode to Cool and the Fan to Low with the temperature set in the middle.
NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.
•Heat Mode: Use the Heat mode at Low, Med, High or Auto Fan Speed for heating. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F in 1°F increments.
•For Normal Heating - Set the Mode to Heat and the Fan to High or Med with the termperature set in the middle.
•For Maximum Heating - Set the Mode to Heat and the Fan to High with a lower set temperature.
•For Quieter & Nighttime Heating - Set the Mode to Heat and the Fan to Low with the temperature set in the middle.
•Energy Saver Mode - Controls the Fan
On - The fan will cycle on and off with the compressor. This results in winder variations of room temperature and humidity. Normally used with the room is unoccupied. NOTE: The fan my continue to run for a short time after the compres- sor cycles off.
Off - The fan runs all the time in fan or cooling mode.
•Fan Only Mode: Use Fan Only mode at Low, Med, or High fan speed to provide air circulation and filtering without cooling. Since fan only setting do not provide cooling, a Set temperature cannot be entered. The room temperature will appear in the display.
NOTE: Auto Fan Speed cannot be used in Fan Only mode.
•Loss of Power Protection: If power to the air conditioner is lost or interrupted, the air condi- tioner will automatically
•Air Direction: Use the lever near on the front air vents to adjust the direction of the airflow. You can direct the airflow left or right only. The lever is located on the right side of the air vent.
16