HP 3150 manual Control panel messages Message Cause Solution, Communication Error

Table 9. Control panel messages

Message	Cause			Solution
Communication Error	An error occurred while trying to transmit			Try again to send the fax.
	a fax. Brief descriptions of communication			Try to send the fax to another fax
	errors are listed below:			machine.
				Make sure the telephone cord is
	60		no RTC at end of fax	securely connected. Then, check for a
	81		memory filled up	dial tone on the phone line by pressing
	82		fax was too short	MANUAL DIAL.
	84		power fail while receiving	Make sure the phone line is working by
	85		failed to train	disconnecting the HP LaserJet 3100/
	86		in ECM, fax data had error(s)	3150 product, plugging in a telephone to
	87		NEC failed to decode (T.4 or T.6	the phone line, and making a voice call.
			coding error	Connect the product to a different phone
	88		received scan line exceeds 13 sec	line.
			(T.4-3.2)	Reset the product by pressing and
	89		modem setup timeout	holding STOP/CLEAR for seven seconds.
	90		low speed command time out	Wait and try resending the fax later.
	91	bad low speed command
	92	transmit error: no DIS
	93	transmit error: no answer
	94	transmit error: canceled by operator
	95	transmit error: failed to train
	96		transmit error: busy
	97	transmit error: no dial tone
	100		poll-in error: no document to poll
	101		document jam
	102		receive error: too many mailbox
			logs
	103		receive error: had poll document but
			no memory for receive
	104		transmit error: no MCF
	105		image processing chip fell behind
	106		transmit: modem output buffer error
	107		PIN received
	108		RR/RNR timeout
	109		generic ECM error
	110		possible missing/partial pages in
			ECM
	111		T4 bit not set in DIS
	112		wrong password
	113		communications error in remote
			setup (JetFax only)
	114		fax document was lost (JetFax only)
	115		blacklist
	116		SUB/PWD error
	117		timeout waiting for image
			processing chip
	118		no fax detected
	119		remote access
	120		caller disconnected prematurely

42 Installation and operation EN