Soleus Air SG-TTW-12HC manual To Operate on FAN only YOU will see

Air Conditioner Features(continued)

TO OPERATE ON FAN ONLY:		YOU WILL SEE:
		LIGHT ON
	DO THIS:

PRESS

MODE BUTTON

CHOOSE

FAN ONLY

Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any fan speed you prefer,EXCEPT AUTO FAN.

During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode.

TO USE THE

ENERGY SAVER FEATURE:

LIGHT ON YOU WILL SEE:

DO THIS:

PRESS

MODE BUTTON

CHOOSE

ENERGY SAVER

Note: In this mode, the fan will continue to run for a short time after the compressor cycles off.

TIMER-DELAY START/STOP FEATURE:

	YOU WILL SEE
FIRST	THE TIME CHOSEN:
DO THIS:
PRESS TIMER
BUTTON

THEN

DO THIS:

PRESS TEMP/TIMER

BUTTON

LIGHT ON

Note 1: For Delay Stop, the unit must be in the ON position.

Note 2: For Delay Start, the unit must be in the OFF position.

To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour increments up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7, etc.). After set Timer,the unit will enter into Timer mode by 5 seconds, then Timer light on, Set light off. In Timer mode: Set temperature and fan speed keeps previously set temperature and fan speed; Temperature display set temperature, no display if power turn off; Press Timer once, LED display remaining time of set time, LED return to set temperature by 5 seconds;

When in Fan Only mode, LED only display room temperature, do not display set temperature.Turning the unit "ON" or "OFF" at any timer will cancel the Delay Start/Stop function. The delay Start/Stop feature will work until the unit either starts or stops. Once this has happened then the above steps have to be repeated again.

11