Installation, Temperature | Soleus Air air-condition specs

No heat	1.	Power is off.					Check the circuit
	2.	Set	temperature		is	in	Adjust the set value
		improper position
	3.	Connector has fallen off.					Tighten the plug.
	4.	Heater is defective					Change the heater.
	5.	Fuse is open.					Change the fuse.
	6.	Control panel			is	not	Change the circuit panel.
		working.
The fan doesn’t operate	1.	Control panel is faulty.					Change the panel.
	2.	The	capacitor		of	fan	Change the capacitor.
		defective.
	3.	Fan defective.					Change the fan.
Unusual sound or heavy	1.	Installation		of		the	Check Installation.
shaking		air-conditioner				too
		gradient.
	2.	Fan touches with other					Adjust the fan position.
	hardware.
	3.	The	connective		pipelines		Adjust the position between
		collide with each other.					the pipelines.
	4.	The part becomes flexible.					Tighten screws.

Installation

1.Installation preparation

If you need to install the air-conditioner on already existing roof vent, the measure of vent must reach 14×14 (in). If it is not enough of this measurement, you must extend this measurement. If it is larger than this measurement, you must make a wood frame for the vent to meet above measurement.

The gradient of install the platform must no more than 5°. If greater than 5° it can be influenced that condensation water of the air conditioner could overflow.

You must avoid any wire and any pipeline before incision.

2.Please directly install the top of the air-conditioner on the placket and make windward face toward the front of the vehicle, condenser toward the back of the vehicle. Put the seal between air-conditioner and placket, and you can sight the four M10 install bores in the air-conditioner bottom. To those irregular coarse roofs you must have sealant seal up all gaps in order to prevent rainwater infiltrating into room.