ASSEMBLY INSTRUCTIONS
Estimated assembly time: Approximately 5 minutes
1.Remove the fan and packaging materials from the box.
2.Remove the mounting nut from the motor shaft.
1.Position the back grille over the motor shaft, aligning the holes in the back grille with the two knobs that protrude from the motor. Make sure the handle is at the top.
2.Secure the back grille by screwing on the mounting nut. Turn clockwise and tighten firmly.
1.Slide the fan blade onto the mounting shaft with the shaft sleeve facing the motor.
2.Align securing screw with flat groove in the motor shaft and tighten with Phillips screwdriver.
1.Position front grille so logo is horizontal.
2.Secure the top tab to the back grille.
3.Snap the four remaining metal clips to the assembly.
4.Apply screw on the bottom of the grille to complete the assembly.
Required Tool: Phillips screw driver
6