HP 4300P C7A41UT#ABA manual Packaging Materials, RoHS Compliance, Material Usage

QuickSpecs

HP Compaq Pro 4300 Small Form Factor Business PC

Technical Specifications - Environmental Data

This product is in compliance with the IEEE 1680 (EPEAT) standard at the Gold level where HP registers commercial desktop products. See http://www.epeat.net for registration status in your country.Plastics parts weighing over 25 grams used in the product are marked per ISO 11469 and ISO1043.

This product contains 0% post-consumer recycled plastic (by wt.)

This product is 93.9% recyclable when properly disposed of at end of life.

Packaging Materials	External	Paper Corrugated - 2300 g
	Internal	PLASTIC/EPS (Expanded Polystyrene) - 63.4 g
		PLASTIC/Polyethylene low density - 56 g
		PLASTIC/Polypropylene - 15 g
	The PAPER/Corrugated packaging material contains at least 30.66% recycled content.
	The PLASTIC/EPS (Expanded Polystyrene) packaging material contains at least 5% recycled content.
	The PLASTIC/Polyethylene low density packaging material contains at least 5% recycled content.
	The PLASTIC/Polypropylene packaging material contains at least 5% recycled content.
RoHS Compliance	Hewlett-Packard is committed to compliance with all applicable environmental laws and
	regulations, including the European Union Restriction of Hazardous Substances (RoHS) Directive.
	HP's goal is to exceed compliance obligations by meeting the requirements of the RoHS Directive on
	a worldwide basis. By July 1, 2006, RoHS substances will be virtually eliminated (virtually = to levels
	below legal limits) for all HP electronic products subject to the RoHS Directive, except where it is
	widely recognized that there is no technically feasible alternative (as indicated by an exemption
	under the EU RoHS Directive).
Material Usage	This product does not contain any of the following substances in excess of regulatory limits (refer to
	the HP General Specification for the Environment at:
	http://www.hp.com/hpinfo/globalcitizenship/environment/supplychain/
	gen_specifications.html):

Asbestos

Certain Azo Colorants

Certain Brominated Flame Retardants - may not be used as flame retardants in plastics Cadmium

Chlorinated Hydrocarbons Chlorinated Paraffins Formaldehyde

Halogenated Diphenyl Methanes Lead carbonates and sulfates Lead and Lead compounds Mercuric Oxide Batteries Ozone Depleting Substances Polybrominated Biphenyls (PBBs) Polybrominated Biphenyl Ethers (PBBEs) Polybrominated Biphenyl Oxides (PBBOs) Polychlorinated Biphenyl (PCB) Polychlorinated Terphenyls (PCT)

Polyvinyl Chloride (PVC) - except for wires and cables, and certain retail packaging has been voluntarily removed from most applications.

Radioactive Substances

Tributyl Tin (TBT), Triphenyl Tin (TPT), Tributyl Tin Oxide (TBTO)

Nickel finishes that release greater than 0.5 micro-grams/cm2/week, measured according to EN 1811:1998, are not used on any product surface designed to be frequently handled or touched by users.

DA - 14288 North America — Version 22 — December 16, 2013 Page 53