installing the Ethernet card
1The following diagram shows where the Ethernet card will be positioned after you have installed it as described below starting with step #2:
2Remove the computer’s cover (refer to the computer’s documentation for instructions).
3Locate the PCI slots (they are beige or white). If there is a faceplate covering the slot, remove it, saving the screw, if any.
4Firmly press the Ethernet card all the way into an empty PCI slot until it is snugly seated.
Note: Be sure to install the card properly to avoid reopening your computer later.
5If you removed a screw from a PCI slot faceplate, screw it into the corresponding end of the Ethernet card faceplate.
6Reinstall the cover on the computer.
7Reconnect the cables to the computer as noted in step 4 of “before you begin.”
Ethernet network interface card | 3 |
Filename: QS Ethernet NIC.doc | Title: |
| |
Template: QS Phoneline GW.dot | Author: Rob Heiret | Last Saved By: Elizabeth Stoneburg | |
Revision #: 65 | Page: 3 of 12 | Printed: 09/04/01 05:48 PM | |