HP NC522SFP manual Connecting the network cable

Page 11

2.Using a correctly sized Phillips head screwdriver, carefully remove the two board lock screws located at the top and bottom of the connector.

3.Remove the standard profile bracket and place the low profile bracket over the connector. Be careful not to damage the connector or bend the low profile bracket.

4.Reinstall the two Phillips screws.

5.Orient the SFP modules with the label side down and then reinstall the modules all the way into their sockets until they click into place and latch securely.

Connecting the network cable

The HP NC522SFP Dual Port 10 GbE Server Adapter uses two SFP+ ports. These ports support either direct attached cable or optical modules. See Cable specifications (on page 12) for the maximum cable length.

Installing an adapter 11

Image 11
Contents Part Number March 2009 First Edition HP NC522SFP Dual Port 10 GbE Server Adapter User GuideIntended audience Contents Technician notes HP contact information Downloading filesOverview LED indicatorsIntroduction Fiber Optic Cable Part number 0.5 to 50 m LED indicator Status DescriptionSFP+ module Part number Preventing electrostatic discharge Installing an adapterInstallation overview Installing a low profile bracket Installing an adapter in a serverConnecting the network cable Compliance SpecificationsCable specifications General specificationsPower Value Environmental Specifications Power and environmental specificationsEuropean Union regulatory notice Regulatory compliance noticesRegulatory compliance identification numbers Federal Communications Commission noticeCanadian notice Grounding methods to prevent electrostatic discharge Electrostatic dischargeAcronyms and abbreviations Index