HP 550 manual

Before removing the system board, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 39).

5.Remove the following components:

a.Hard drive (see Hard drive on page 40)

b.Optical drive (see Optical drive on page 46)

c.Keyboard (see Keyboard on page 50)

d.Switch cover (see Switch cover on page 48)

e.Speaker (see Speaker on page 53)

f.Display lid switch module (see Display lid switch module on page 54)

g.Display assembly (see Display assembly on page 55)

h.Top cover (see Top cover on page 60)

When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board:

●Memory module (see Memory module on page 45)

●WLAN module (see WLAN module on page 42)

●Processor (see Processor on page 74)

●ExpressCard assembly (see ExpressCard assembly on page 79) Remove the system board:

1.Remove the RJ-11 jack (1) from the clip built into the base enclosure and remove the RJ-11 jack cable from the hook (2) built into the base enclosure.

Component replacement procedures 67