HP L2245W, L2208W, L1908WM, L1950, L1945WV, L1710, L1750 manual Removing the Monitor Pedestal Base

Removing the Monitor Pedestal Base

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm, or other mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect it.

1.Disconnect and remove the signal and power cables from the back of the monitor.

2.Lay the monitor face down on a flat surface.

3.Remove the screws on the back of the monitor that connect the monitor panel with the pedestal base.

a.On the double-hinged base, there are four screws that connect the monitor panel to the pedestal base.

Figure 3-16Removing the Double-Hinged Pedestal Base

16 Chapter 3 Setting Up the Monitor