Toshiba RAV-SM802AT-E, SP562AT-E, SP802AT-E Correct Usage, Preparation, Stop, Push on / OFF button

ON / OFF

CORRECT USAGE

When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce- dure below. From the next time, the operation displayed on the remote controller will start by pushing the

button only.

Preparation

Turn on the main power switch and/or the leakage breaker.

• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.

*After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but it is not a failure.

REQUIREMENT

• While using the air conditioner, operate it only with ON / OFF button without turning off the main power switch and the leak breaker.

TEMP.		ON / OFF
4
TIMER SET	FAN	MODE
TIME	SWING/FIX	VENT
FILTER
RESET TEST SET CL	UNIT

1 Push ON / OFF button.

3

1

2

The operation lamp goes on, and the operation starts.

2 Select an operation mode with the “MODE MODE ” button.

One push of the button, and the display changes in the order shown on the right.

AUTO HEAT DRY COOL FAN

•In HEAT mode, if the room temperature reaches to the set temperature, the outdoor unit stops and the air flow becomes LOW and the air volume decreases.

3

4

• In the defrost mode, the fan stops so that cool air is not discharged and PRE-DEF is displayed.

Select air volume with “	FAN	” button.	AUTO	HIGH	MED.	LOW
One push of the button, and the display
changes in the order shown on the right.

•When air volume is “AUTO ”, air volume differs according to the room temperature.

•In DRY mode, “AUTO ” is displayed and the air volume is LOW.

•In heating operation, if the room temperature is not heated sufficiently with VOLUME “LOW ” opera-

tion, select “MED. ” or “HIGH ” operation.

Determine the set up temperature by pushing the “TEMP. ” or “TEMP. ” button.

Stop

Push ON / OFF button.

The operation lamp goes off, and the operation stops.

6