HP R927 manual Camera, Install the battery, Charge the battery

2	Setting up your
	camera

Install the battery

1. Open the Battery/Memory card door by sliding the door latch as indicated on the Battery/Memory card door.

2. Insert the battery in the larger slot, pushing the battery in until the latch catches.

3. Close the Battery/Memory card door.

Note Turn the camera off before removing the battery. Fully charge the battery before using it the first time.

Charge the battery

You can charge the battery in the camera, using the camera dock.

1. Connect the AC power

adapter to the dock, then plug it into an electrical outlet.

2. Put the camera in the dock. The camera’s

blinking Battery

Charging light indicates that the battery is charging; the battery is fully charged when the light turns on solid (approximately 2–3 hours).

English

Setting up your camera 11