HP 930 manual Focus too far, Focus too close, To focus, Unable to focus, Blinking

	Message	Possible cause	Solution
	Focus too far	The focus	Make sure the camera is
		distance is	not set to Macro		focus.
		beyond where	Consider setting the
		the camera can	camera to Infinity		focus
		focus.	if your picture subject is far
			in the distance.
	Focus too close	The focus	Set the camera to
		distance is closer	Macro	focus, or if
		than the camera	set to Macro focus,
		can focus.	move further away from
			the subject.
	Low light - unable	The scene is too	Add an external light
	to focus	dark and the	source, or use Focus Lock
		camera cannot	(see page 27) and point at
		focus.	a part of the scene that is
			brighter.
	Unable to focus	The camera is set	Set the camera to Normal
	and blinking	to Macro	focus, and try taking the
		focus, but the	picture again. (See Setting
		subject for the	the focus range on
		picture is too far.	page 30.)
		The subject did	Use Focus Lock before
		not provide	taking the picture (see
		enough contrast	page 27).
		for the camera to
		focus properly.
		The light is low	Use the flash (see Setting
		and the image is	the flash on page 33), or
		likely to be	use a tripod.
		blurry due to the
		long exposure
		required.
Chapter 7: Troubleshooting and support					87