HP 8612 (AP), 6744 (US), 6730 (US/CAN), 6657 (LA), 6649F (US/CAN), 6648C (US), 6644D (US), 6644F (US)

Product Manual Page Product Manual Page Contents Configuring and mounting the drive ATA interfaceFigures U10 Family Product Manual, Rev. a Introduction Specification summary table Drive Specification ST320423A Contact start-stop cycles 25C 40% relative humidity Default logical geometry Formatted capacityPhysical organization Physical characteristics Drive Specification ST320423A, ST315323A ST310212ARecording and interface technology Power specifications Seek timeStart/stop times Power consumption Power Mode Typical Watts Typical Amps RMS 12V Typical current profilePower-management modes Conducted noiseVoltage tolerance Sleep mode Environmental tolerances Ambient temperatureTemperature gradient Idle and Standby timersAltitude 3.2 Wet bulb temperatureHumidity 3.1 Relative Humidity ShockOperating vibration Nonoperating vibrationDrive acoustics Reliability Agency certification Safety certificationElectromagnetic susceptibility Electromagnetic compatibilityFCC verification Australian CE-Tick N176U10 Family Product Manual, Rev. a Configuring and mounting the drive Handling and static-discharge precautionsJumper settings Master/slave configuration Drive as master with a non-ATA-compatible slaveCable-select option Ultra ATA/66 cableDrive mounting Mounting dimensions-top, side and end view ATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Supported ATA commands Command name Command code in hex ATA-standard commandsATA-standard power-management commands Identify Drive commandCommand name ATA-standard security commandsWord Description 0C5AHWord Description Value Xx07HXx1FH Description if bit is set to Bit Word Set Features command 0CH4 S.M.A.R.T. commands Code in Features A.R.T. Command RegisterA.R.T. Command Register Page