![](/images/new-backgrounds/1212677/2126779x1.webp)
1Preparing the computer for wall- mounting
This document provides instructions for preparing your HP
To convert the computer from a
What you need
●
◦VESA standard 100 mm x 100 mm (3.9 in. x 3.9 in.) hole pattern
◦Designed for
●A stable, flat surface to place the computer
●A soft, clean cloth (such as a clean, large towel) to protect the computer when you place it face down
●Antistatic wrist strap and a conductive foam pad to stand on while working on the computer (recommended)
●A Phillips #2 screwdriver
●Another person (the computer is heavy and might require two people to lift and move it)
Safety information
This product has not been evaluated for connection to an “IT” power system (an AC distribution system with no direct connection to the earth, according to IEC 60950).
WARNING! Always disconnect the computer from the power source before removing the computer stand. Failure to do so before you perform any procedures can result in personal injury or equipment damage.
WARNING! Avoid touching sharp edges inside the computer.
WARNING! It is recommended that you use only
WARNING! The computer is heavy. Take proper precautions when lifting or moving the computer.
What you need | 1 |