HP SR5780D manual Lithium Battery Caution Laser Safety Statement, TV Antenna Connectors Protection

Page 12

WARNING: Always disconnect the modem cord from the telephone system before installing or removing your computer cover.

WARNING: Do not operate the computer with the cover removed.

WARNING: For your safety, always unplug the computer from its power source and from any telecommunications systems (such as telephone lines), networks, or modems before performing any service procedures. Failure to do so may result in personal injury or equipment damage. Hazardous voltage levels are inside the power supply and modem of this product.

Lithium Battery Caution

WARNING: The computer uses a lithium battery, type CR2032. There is danger of an explosion if the battery is incorrectly replaced. Replace only with the same, or equivalent, type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

Laser Safety Statement

Class 1 LED Product

The CD and DVD drives contain a laser system and are classified as a “Class 1 Laser Product” under a

U.S. Department of Health and Human Services (DHHS) Radiation Performance standard according to the Radiation Control for Health and Safety Act of 1968.

Should the unit ever require maintenance, contact an authorized service location.

WARNING: Use of controls, adjustments, or performance procedures other than those specified in the Upgrading and Servicing Guide may result in hazardous radiation exposure.

To prevent direct exposure to laser beam, do not try to open the enclosure of the CD or DVD drives.

Laser Product Label

The following label or equivalent is located on the surface of laser products:

This label indicates that the product is classified as a

CLASS 1 LASER PRODUCT. This label appears on a laser device installed in your product.

TV Antenna Connectors Protection

External Television Antenna Grounding

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is electrically grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper electrical grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

12

Image 12
Contents Limited Warranty and Support Guide General Terms HP ProductExclusions Exclusive RemedyLimitation of Liability Limited Warranty Period Types of Warranty ServiceService Upgrades Options and Software Limited WarrantiesHow to Check Warranty and Support Entitlement Software Technical SupportContacting HP Transfer Page Declaration of Conformity Chemical Substances Audio volume statement Australia Telecom StatementAC Power Safety Warning New Zealand Telecom StatementFor automatically initiated calls to the same number Lithium Battery Caution Laser Safety Statement TV Antenna Connectors ProtectionClass 1 LED Product Laser Product LabelLightning Protection Where to Get Help Follow these steps when you need helpDon’t Forget to Register Where Are My User Guides? Software SupportTo Our Valued Customer Xtra New ZealandProblems? HP Will Help Customer SupportGetting Started See What You Can DoPage Page Page Printed
Related manuals
Manual 32 pages 62.95 Kb Manual 1 pages 8.29 Kb