3Make sure the jumper on the new optical drive or hard drive is in the CS (Cable Select) position. Your drive may vary from the illustration.
NOTE: An optical drive may include a sound cable. Connect this cable also.
cable select jumper
connecting the memory card reader drive cable
4Install four guide screws on the sides of the new drive (two on each side). The screws help guide the drive into its proper position in the bay.
5 Slide the drive partway into the drive bay, making sure to align the guide screws with the guide slots.
connecting the diskette (floppy) drive cables
6 Reconnect the power and data cables to your drive as indicated in the following illustrations.
| connecting the hard disk drive cables |
7 | Push the drive the rest of the way into the bay until |
| the drive snaps into place. |
8 | Complete the procedures to replace the front panel, |
connecting the optical drive cables | replace the side panel, and close the PC. See |
“opening and closing the pc“ on page 1. |
Upgrading and Servicing Guide 5