York Y32, Y33, Y34 List of Features and Benefits, Standard Features, Factory Installed Options

246653-YTG-E-0108

LIST OF FEATURES AND BENEFITS

Standard Features

•9.5 EER (10 EER on 25 ton)

•Double wall construction

•Major components have hinged and latched access doors

•Industrial duty scroll compressors

•Sturdy framed construction

•Sloped stainless steel or powder coated drain pan

•Separate 10 ton circuits (30 and 40 ton units) or 12.5 ton (25 ton unit)

•Intertwined evaporator coil

•Angled condenser coils for superior protection

•Single power point connection

•Through-the-curb or through-the-base utility connections

•Retractable outside air hoods

•Powder paint tested to 1000 salt spray hours

•Mechanical cooling from 40° F to 125° F

•1-1/2” insulation

•Sloped unit roof with drip lip

•High and low refrigerant pressure protection

•Polyurethane sleeves to protect small diameter tubing

•Steel framing around blowers with deflection springs or rubber isolators for low vibration

•Fully factory packaged and run-tested

•10 year gas heat exchanger warranty

•One year compressor warranty

•One year warranty on all parts

Factory Installed Options

•Economizer with standard or low leak dampers

•Natural gas standard or modulating gas heat with reli- able induced draft design

•Electric heat in three sizes

•Variable air volume using either inlet guide vanes, wired for VFD (variable frequency drive), or factory installed VFD.

•1, 2” blower isolator springs or rubber isolators

•A variety of blower horsepower offerings

•High efficiency motors

•High efficiency filtration

•Barometric relief

•Power exhaust of 100% of nominal air flow

•Technicoat corrosive resistant coating on condenser and evaporator coils

•Copper-Copper corrosive resistant condenser and evap- orator coils

•0°F low ambient operation of mechanical cooling

•Hot gas bypass (standard on all VAV units)

•High capacity evaporator coils

•Single unit disconnect

•Convenience outlet and transformer factory wired

•Hot water heating coil with one or two rows

•One row steam heating coil

•Simplicity® Elite™ controls

•ModLINC translator

•York Commercial Comfort System (YCCS)

Field Installed Accessories

•7-Day Programmable Wall Thermostat-Can be used with or without remote sensors. Can be used on CV and VAV units when wall thermostat is required for scheduling and temperature control.

•Energy Recovery Ventilators- 8,000 and 13,000 CFM models available. Great for applications involving 30% or more of required outdoor air where energy use and com- fort must be optimized.

•Wall Sensors- Remote space sensors used with CV or VAV unit for unit control via the Simplicity® Elite™ con- trol. Standard sensor, sensor with override and sensor with override and + 5 degree adjustment.

•Simplicity® Transporter- Device allows internet control and monitoring of HVAC units equipped with Simplicity® Elite™ controls.

•Phase Monitor Kit- Includes control and wiring to monitor and protect the unit from phase reversal, phase loss and low voltage.

•Burglar Bars- Prevent any type of building entry through the RTU unit with bars that block the return and supply openings on downflow applications.

•Partial perimeter roofcurb- Designed for application on all 25-40 ton Millennium rooftop units. 14" height.

•Barometric Relief Kit- Provides barometric relief hood and dampers for duct mounting on units requiring end return.

•Natural Gas to Propane Conversion Kits- Contains ori- fices and gas valves parts to convert from Natural Gas to Propane. (Not available on modulating heat.)

•High Altitude Kit- Natural gas kit designed for natural gas heating applications between 2,000 and 6,000 feet above sea level.

8 Johnson Controls Unitary Products