HP dx7400 manual Enww

Page 28

b.Insert the new battery and position the clip back into place. Figure B-3Removing a Coin Cell Battery (Type 3)

NOTE: After the battery has been replaced, use the following steps to complete this procedure.

8.Replace the computer access panel.

9.Plug in the computer and turn on power to the computer.

10.Reset the date and time, your passwords, and any special system setups using Computer Setup. Refer to the Computer Setup (F10) Utility Guide.

11.Lock any security devices that were disengaged when the computer access panel was removed.

22 Appendix B Battery Replacement

ENWW

Page 27 Page 29
Image 28
Page 27 Page 29
Contents
Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Enww Standard Configuration Features Product FeaturesServiceability Features Keyboard 1Keyboard ComponentsUsing the Windows Logo Key 2Windows Logo Key FunctionsEnww Hardware Upgrades Removing the Computer Access Panel and Front Bezel2Removing the Front Bezel Hardware Upgrades Removing a 5.25 Drive Bezel Blank 3Removing a 5.25 Bezel Blank4Removing a 3.5 Bezel Blank Hardware Upgrades Removing a 3.5 Drive Bezel BlankInstalling Additional Memory Installing DIMMsDIMMs DDR2-SDRAM DIMMsEnww Installing an Expansion Card Enww Replacing or Upgrading a Drive Locating Drive PositionsDrive Configuration System Board Connectors System Board Drive ConnectionsRemoving a 5.25 Optical Drive Removing a 3.5 Media Card Reader or Diskette Drive Device Retainer Screws Guide ScrewsRemoving a 3.5 Hard Drive 12Removing a 3.5 Hard Drive Installing a Security Lock 13Installing a Security Lock Hardware UpgradesSpecifications Table A-1SpecificationsBattery Replacement Type Enww Computer Operating Guidelines and Routine Care Optical Drive Precautions CleaningSafety Shipping PreparationPreventing Electrostatic Damage Electrostatic DischargeGrounding Methods Index
Related manuals
Manual 4 pages 22.69 Kb Manual 19 pages 31.06 Kb Manual 4 pages 60.67 Kb
Top Page Image Contents