b.To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2).
Figure B-2 Removing and Replacing a Coin Cell Battery (Type 2)
Type 3
a.Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.Insert the new battery and position the clip back into place.
Figure B-3 Removing a Coin Cell Battery (Type 3)
NOTE After the battery has been replaced, use the following steps to complete this procedure.
8.Replace the computer access panel.
9.Plug in the computer and turn on power to the computer.
10.Reset the date and time, your passwords, and any special system setups using Computer Setup. Refer to the Computer Setup (F10) Utility Guide on the Documentation and Diagnostics CD.
11.Lock any security devices that were disengaged when the computer access panel was removed.
ENWW | 39 |