HP dx2420 manual Battery Replacement

Page 48

B Battery Replacement

The battery that comes with the computer provides power to the real-time clock. When replacing the battery, use a battery equivalent to the battery originally installed in the computer. The computer comes with a 3-volt lithium coin cell battery.

WARNING! The computer contains an internal lithium manganese dioxide battery. There is a risk of fire and burns if the battery is not handled properly. To reduce the risk of personal injury:

Do not attempt to recharge the battery.

Do not expose to temperatures higher than 60°C (140ºF).

Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.

Replace the battery only with the HP spare designated for this product.

CAUTION: Before replacing the battery, it is important to back up the computer CMOS settings. When the battery is removed or replaced, the CMOS settings will be cleared. Refer to the Computer Setup (F10) Utility Guide for information on backing up the CMOS settings.

Static electricity can damage the electronic components of the computer or optional equipment. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object.

NOTE: The lifetime of the lithium battery can be extended by plugging the computer into a live AC wall socket. The lithium battery is only used when the computer is NOT connected to AC power.

HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable batteries. For more information about recycling programs, go to http://www.hp.com/ recycle.

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as diskettes or compact discs, from the computer.

3.Turn off the computer properly through the operating system, then turn off any external devices.

4.Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

5.Remove the computer access panel.

6.Locate the battery and battery holder on the system board.

42 Appendix B Battery Replacement

ENWW

Image 48
Contents Hardware Reference Guide dx2420 Microtower Model Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Product Features Standard Configuration FeaturesFront Panel Components 1Front Panel ComponentsMedia Card Reader Components 2Media Card Reader ComponentsRear Panel Components 3Rear Panel ComponentsKeyboard 4Keyboard ComponentsUsing the Windows Logo Key 5Windows Logo Key FunctionsSerial Number Location 6Serial Number and Product ID LocationHardware Upgrades Removing the Computer Access Panel 1Removing the Computer Access PanelReplacing the Computer Access Panel 2Replacing the Computer Access Panel Hardware UpgradesRemoving the Front Bezel 3Removing the Front BezelRemoving Bezel Blanks Replacing the Front Bezel 5Replacing the Front BezelInstalling Additional Memory DIMMsDDR2-SDRAM DIMMs Populating Dimm Sockets 1DIMM Socket LocationsInstalling DIMMs Enww Removing or Installing an Expansion Card 2Expansion Slot LocationsRemoving or Installing an Expansion Card 11Removing a Standard PCI Expansion Card Hardware Upgrades Enww Enww Drive Positions 15Drive PositionsInstalling Additional Drives 16Extra Drive Retainer Screws Location Hardware UpgradesInstalling Additional Drives System Board Drive Connections 3System Board Drive ConnectionsRemoving an Optical Drive 19Removing the Optical Drive Hardware Upgrades Installing an Optical Drive into the 5.25-inch Drive Bay 20Installing the Optical DriveRemoving an External 3.5-inch Drive Enww Installing a Drive into the 3.5-inch External Drive Bay 24Removing a 3.5-inch Device Media Card Reader ShownEnww Removing an Internal 3.5-inch Hard Drive Enww 30Removing the Hard Drive Hardware Upgrades Installing an Internal 3.5-inch Hard Drive 31Installing the Hard Drive in the Drive Cage33Installing the Hard Drive Cage Hardware Upgrades Enww Specifications Table A-1SpecificationsRated Input Current maximum Battery Replacement Type Enww Installing a Security Lock External Security DevicesCable Lock Padlock HP Business PC Security LockEnww Enww Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Computer Operating Guidelines and Routine Care Optical Drive Precautions CleaningSafety Shipping PreparationIndex Enww
Related manuals
Manual 3 pages 7.73 Kb