![](/images/new-backgrounds/1152778/15277865x1.webp)
3.Connect the power and data cables to the drive as indicated in the following illustrations.
a.If you are installing an optical drive, connect the power cable (1) and data cable (2) to the back of the drive.
Figure 2-20 Connecting the Optical Drive Cables
CAUTION Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A sharp bend can break the internal wires.
b.If you are installing a diskette drive, connect the data cable (1) and power cable (2) to the back of the drive.
Figure 2-21 Connecting the Diskette Drive Cables
4.If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.
ENWW | Installing Additional Drives 27 |