HP mx705, MV7540, S7540, v7650 17-inch manual Connecting the Cables, Removing the Monitor Base

Setting Up the Monitor

Removing the Monitor Base

In the event that you need to disassemble the base from the monitor, position the monitor bottom side up and follow these instructions:

1.If you must remove the base attachment, release the catch and slide the base toward the back of the monitor.

2.Lift the base up and away from the monitor.

Connecting the Cables

Before setting up the monitor, place it in a convenient, well-ventilated location near the computer.

1.Turn off the power to the computer and other peripheral devices.

2.Connect the power cord 1 to the back of the monitor, then connect the power cord to a power outlet.

3.Connect the video cable (blue connector) 2 from the back of the monitor to the blue 15-pin connector on the back of the computer. Tighten the cable screws to secure the cable to the connector.

ÄCAUTION: To avoid damaging the video cable, ensure that the cable aligns with the 15-pin connector. Do not force the cable onto the connector.

3–2 User Guide