HP manual Storing the HP TFT7210R, Moving a rack with the HP TFT7210R installed

Storing the HP TFT7210R

1.Pull the release mechanism toward you with your index fingers to unlock the inner slides.

2.In the same motion, release the release mechanism and move the HP TFT7210R forward into the stored position.

WARNING: To reduce the risk of personal injury, release the release mechanisms after pushing the HP TFT7210R slightly forward.

Moving a rack with the HP TFT7210R installed

When moving the HP TFT7210R installed in a rack, HP recommends installing the lock plates.

1.Fully extend the HP TFT7210R until the slides lock into place.

2.Place a lock plate behind the corner of the front plastic bezel, being sure that the top and bottom holes are aligned with the front plastic bezel pins.

3.From behind the corner of the front plastic bezel, insert a 6-32 screw into the middle hole on the lock plate, securing it to the HP TFT7210R.

4.Repeat steps 2 and 3 to install the other lock plate.

5.Push the HP TFT7210R back into the rack.

6.Insert an M6 screw into the only visible lock plate hole, securing the HP TFT7210R to the rail.

Maintenance 21