HP LP2065 20' manual Troubleshooting

Troubleshooting

Problem	Possible Cause	Solution
Image appears	Brightness and contrast	Press the -/Auto button on
blurred, indistinct, or	are too low.	the front panel. If this does
too dark.		not correct the image, press
		the Menu button to open the
		Basic OSD Menu, and
		adjust the brightness and
		contrast scales as needed.
Image is not	Position may need	Press the Menu button to
centered.	adjustment.	access the OSD menu.
		Select Image Control/
		Horizontal Position or
		Vertical Position to adjust the
		horizontal or vertical
		position of the image.
“Check Video	Monitor video cable is	Connect the DVI-D signal
Cable” is displayed	disconnected.	cable to the DVI-I connector
on screen.		on the computer, or the
		VGA to DVI-I cable to the
		DVI-I connector on the
		computer. Be sure that the
		computer power is off while
		connecting the video cable.

“Out of Range. Set Monitor to 1600 x 1200 @ 60Hz” is displayed on screen. (HP LP2065 20” Model)

Video resolution and/or refresh rate are set higher than what your monitor supports.

Restart your computer and enter Safe Mode. Change your settings to a supported setting (see “Factory Preset Display Modes” table in Appendix B). Restart your computer so that the new settings take effect.

A–2 User Guide