HP LA1956X, LA2006X, LA2206X manual Removing the Stand from the HP LA1956x Monitor

Page 22

Removing the Stand from the HP LA1956x Monitor

You can remove the monitor panel from the monitor stand to attach the panel to a wall, a swing arm, or another mounting fixture.

NOTE: The following steps apply only to the HP LA1956x Model.

1.Lay the monitor face down on a flat surface covered by a clean, dry cloth.

2.Remove the four screws from the monitor stand.

Figure 2-18Removing the Screws from the Monitor Stand

16 Chapter 2 Setting Up the Monitor

ENWW

Image 22
Contents User Guide Fourth Edition June Document Part Number About This Guide About This Guide Table of contents Enww Product Features HP LCD MonitorsEnww Setting Up the Monitor Unfolding the Monitor Pedestal BaseAttaching the Stand to the HP LA1956x Monitor Rear Components Component FunctionConnecting the Cables 3Removing the Cable Management ClipConnecting the Cables 5Connecting the Cables 7Installing the Cable Management Clip Front Panel Controls Monitor Front Panel ControlsAdjusting the Monitor 12Adjusting the Height Turning on the Monitor 14Pivoting the MonitorConnecting USB Devices 15Connecting USB Devices Setting Up the MonitorRemoving the Monitor Pedestal Base 17Removing the Pedestal BaseRemoving the Stand from the HP LA1956x Monitor Mounting the Monitor Installing a Cable Lock Locating the Rating LabelsReference Guides Finding More InformationProduct Support Table A-1LA1956x Specifications Technical SpecificationsLA1956x Model Table A-2LA2006x Specifications LA2006x ModelTable A-3LA2206x Specifications LA2206x ModelTable A-4LA2306x Specifications LA2306x ModelEnww LA1956x Model Recognizing Preset Display ResolutionsLA2006x Model LA2206x Model Table A-8Factory Preset ModesTable A-10Factory Preset Modes LA2306x ModelEntering User Modes Energy Saver FeatureTable A-11High Definition Video Formats