After the Installation

Installing Component for Remote Access by XAPI Agents

Where an XAPI Agent (that is, an Agent using the MAILbus 400 Application Program Interface) is to be installed on a system remote from the MTA, select the option to install the MAILbus 400 MTA Base component on the single node, or on one node in the cluster, where the Agent is to be installed.

The set-up tasks required after installation, and the MTA veriﬁcation procedure are described in Part III of HP MAILbus 400 MTA Planning and Setup.

Before you set up each MAILbus 400 MTA that you have installed, make sure that the Base component of the HP Enterprise Directory Service is installed on each node or cluster where you intend to operate a MAILbus 400 MTA.

Refer to the HP Enterprise Directory Service documentation for details of how to install the Base component of the HP Enterprise Directory Service.

Release Notes and Further Information

After installation, the release notes are kept in

SYS$COMMON:[SYSHLP]MAILBUS400_MTA.RELEASE_NOTES.

HP MAILbus 400 MTA Tuning and Problem Solving contains a list of the ﬁles that should be present on your system after installation, and information about how to contact HP if the installation fails.