Programming a Sequence while a CD is Playing

While the CD changer is playing, you can program a sequence of tracks, but not an entire CD. Press PGM during play, then select the CD and track using the remote control’s number buttons and DISC SET/TRACK SET, and press PGM. When the current track finishes playing or you press 3, programmed play starts.

Or, you can store the track currently being played directly into memory. While the track is playing, press PGM once to enter the program mode, then press PGM again to store the current track. You might find this feature convenient to use along with hi-lite scan.

Erasing a Programmed Selection

In the program mode (when PGM appears on the display), press CLEAR to erase the last-stored selection (track or CD). The new last-stored selection appears on the display until you press 6 (or 3 on the remote control).

Note: You cannot erase a selection that is currently playing or that has already played.

Clearing a Programmed Sequence

Turning off the CD changer does not clear the programmed sequence. To clear the sequence, do any of the following:

•Press 7 when the CD is stopped.

•Start best selection play.

•Select ALL, SINGLE, CUSTOM, previous scan, or play the CD in the single play slot while programming a sequence.

•Press RANDOM while programming a sequence.

Storing a Pause within a Programmed Sequence for Recording to Cassette

When you record a programmed sequence onto a cassette tape, you can program a pause to occur after the last selection you plan to record on the first side of the tape (so you can turn the tape over).

To store a pause, press 8 on the remote in Step 3 of “Programming a Sequence” on Page 13. PA appears on the display.

During play, when the CD changer pauses and displays 6, turn over the tape and press 8 to resume recording.

Notes:

•You cannot program a pause as the first or last selection.

•You cannot program two pauses in a row.