HP LA2205WG, LA2205WL, LA2405x, LA2405wg, LA22F, LA1905WL, LA1905WG manual Turning on the Monitor

Page 15

NOTE: To view information on the screen in portrait mode, you will need to install the Pivot Pro

software included on the software and documentation CD. The position of the OSD menu can also be rotated to portrait mode. To rotate the OSD menu, access the OSD menu by pressing the Menu button on the front panel, select OSD Control, then select Rotate OSD.

Turning on the Monitor

1.Press the power button on the computer to turn it on.

2.Press the power button on the front of the monitor to turn it on.

CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you should always activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. Image retention is a condition that may occur on all LCD screens. Monitors with a “burned-in image” are not covered under the HP warranty.

* A prolonged period of time is 12 consecutive hours of non-use.

NOTE: If pressing the power button has no effect, the Power Button Lockout feature may be enabled. To disable this feature, press and hold the monitor power button for 10 seconds.

NOTE: You can disable the power LED in the OSD menu. Press the Menu button on the front of the monitor, then select Management > Bezel Power LED > Off.

When the monitor is powered on, a Monitor Status message is displayed for five seconds. The message shows which input (DisplayPort, DVI, or VGA) is the current active signal, the status of the auto-switch source setting (On or Off; factory default is On), the default source signal (factory default is DisplayPort), the current preset display resolution, and the recommended preset display resolution.

The monitor automatically scans the signal inputs for an active input and uses that input for the display. If two or more inputs are active, the monitor will display the default input source. If the default source is not one of the active inputs, then the monitor will display the highest ranking priority input in the following order: DisplayPort, DVI, then VGA. You can change the default source in the OSD by pressing the front panel menu button and selecting Source Control > Default Source.

Turning on the Monitor

9

Image 15
Contents User Guide Fifth Edition April Document Part Number About This Guide Iv About This Guide Table of contents Page HP LCD Monitors Product FeaturesPage Unfolding the Monitor Pedestal Base Setting Up the MonitorRear Components Setting Up the Monitor3Connecting the Cables Connecting the Cables1Monitor Front Panel Controls Front Panel ControlsAdjusting the Monitor 7Pivoting the Monitor Setting Up the Monitor Turning on the Monitor Connecting USB Devices Removing the Monitor Pedestal Base Mounting the Monitor Locating the Rating Labels Installing a Cable LockFinding More Information Finding More InformationReference Guides Product SupportLA1905wl/LA1905wg Models Technical SpecificationsTable A-1LA1905wl/LA1905wg Specifications LA1905wl/LA1905wg ModelsAppendix a Technical Specifications Table A-2LA2205wg SpecificationsLA2205wg Model Table A-3LA2205wl/LA22f Specifications LA2205wl/LA22f ModelsLA2205wl/LA22f Models LA2405wg Model Table A-4LA2405wg SpecificationsTable A-5LA2405x Specifications LA2405x ModelLA2405x Model Appendix a Technical Specifications Table A-7Factory Preset Modes Recognizing Preset Display ResolutionsRecognizing Preset Display Resolutions Table A-6Factory Preset ModesEntering User Modes Energy Saver Feature
Related manuals
Manual 28 pages 8.75 Kb Manual 52 pages 13.53 Kb Manual 7 pages 49.76 Kb