HP 2175xi manual Attach the cover, Remove output tray and load paper, Finish software setup

START HERE

Windows 98, 2000, ME,

XP

1 Turn on your PC 2

a	Turn your PC on and wait for the Windows
	desktop to appear.
b	Close any open programs, including virus-
	checking programs.

Windows desktop

Install the software first

a

b

Insert the HP PSC software CD.

Follow the onscreen instructions.

When prompted to plug in the

c device (as shown to the left), go to step 3. Return to your computer in step 9.

If nothing appears on your computer screen after inserting the CD, search for setup.exe on the CD and double-click the file.

Make sure you are using the correct side of the poster.

Windows users: Follow the steps in order. Do not connect the USB cable until instructed to do so.

See your box for exact contents and system requirements.

3 Attach the cover

ab

a	Insert the two bottom tabs of the
	cover into the slots on the unit.
b	Tilt the cover down and press firmly.
	Make sure the tabs lock into place
	and the cover is even with the
	device.

4 Remove output tray and load paper

Use blank white paper to prepare for print alignment.

	b	d
a	c		e

setup poster psc 2170 series all-in-one

5 Connect the power cord and USB cable

a

7 Insert and align the print cartridges

Make sure to remove any packing material from inside the device.

a

b

b

Do not connect the USB cable until you see the screen in Step 2. Do not connect the USB cable to a keyboard or non-powered hub.

c Black label (56)

e

d Color label (57) f

6 Turn on your HP PSC

Turn power On and wait for display prompt.

Note: See the reference guide for adjusting the display viewing angle.

8 Finish software setup

Look at the screen with the green checkmark, and then continue. If you see the screen with the red "X", follow the instructions in the Readme.

g

9 Try your new HP PSC

Windows hp

latches

a	Lift the print carriage door up	b	Remove the bright pink tape
	until it catches. Wait for the
	print carriage to move to the		from the print cartridges. Do not
	center. Lift the blue and gray		touch the gold-colored contacts
	latches.		or retape the cartridges.

c	Hold the black print cartridge with the label on
	top as shown. Slide the cartridge into the right	e Pull the end of the gray latch toward
	(gray latch) side of the print carriage.
d		you, press down until it stops, and then		Make sure both latches
	Hold the color print cartridge with the label on	release. Make sure the latch catches	f
	top as shown. Slide the cartridge into the left	below the bottom tabs. Repeat with the		are locked into position.
	(blue latch) side of the print carriage.	blue latch.		Close the door.

g	Press Enter on the front panel
	to begin alignment. After a
	page prints, alignment is
	complete. Discard or recycle this
	page.

Congratulations! You are now ready to use the HP PSC. Double-click the Director icon to get started.

Make sure there are five icons in the HP Director window.

If not, see the reference guide.

www.hp.com/support Copyright Hewlett-Packard Company 2003 Printed in USA, Mexico, Germany, and Singapore.