HP 6510 - B211a, 6512 - B211a, 6515 - B211a manual Wireless with a router infrastructure network

Chapter 8

❑Press and hold the button on WPS-enabled router or other networking device to activate WPS.

NOTE: The product begins a timer for approximately two minutes in which the corresponding button on the networking device needs to be pressed.

❑Touch OK. c. Install software.

Use PIN method

a. Select setup method. Make sure your WPS-enabled wireless router supports PIN method.

❑From the Home screen, touch the right directional key, and then touch the Wireless icon.

❑Touch WiFi Protected Setup.

❑Touch PIN.

b. Set up wireless connection.

❑Touch Start.

❑Turn on wireless radio if it is off.

NOTE: The product begins a timer for approximately five minutes in which the PIN needs to be entered on the networking device.

❑Touch OK.

c. Install software.

Related topics

Tips for setting up and using a networked printer

Wireless with a router (infrastructure network)

To connect the HP Photosmart to an integrated wireless WLAN 802.11 network, you will need the following:

❑A wireless 802.11b/g/n network that includes a wireless router or access point. NOTE: 802.11n will only support 2.4Ghz.

❑A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The computer must be connected to the wireless network that you intend to install the HP Photosmart on.

36 Connectivity