HP 3310xi manual Connect the Ethernet cable, Section B Ethernet wired network

Page 9

Section B: Ethernet (wired) network

B1	Connect the Ethernet cable
a	a	Remove the yellow plug from the back of the device.
	b	Connect one end of the Ethernet cable to the Ethernet port on
		the back of the device.
	c	Connect the other end of the Ethernet cable to the hub/
		router/switch. If the cable is not long enough, you can
		purchase a longer cable.

Important: Do not connect the Ethernet cable to a cable modem.

You must have a working network. If you already connected the USB cable, do not connect the Ethernet cable.

HP All-in-One • 9

Image 9

Contents Locate components Remove all tape and lift displayLoad paper trays Attach the control panel faceplate if not attachedOpen the access door Connect the power cordConnect the supplied phone cord Press the On button and conﬁgureInsert all six ink cartridges Lift latches inside of the deviceTurn on your computer Close the access door and follow the prompts Wireless Access Point Connection Ethernet Wired Network Choose ONE connection type a or B or C USB Connection Do not connect yetSection a USB Connection A1 Insert the correct CDA3 Go to back of the guide to make a test copy A2 Connect the USB cableConnect the Ethernet cable Section B Ethernet wired networkInsert the correct CD B3 Go to back of the guide to make a test copyC1 Locate wireless settings Section C Wireless Access Point NetworkShortcut methods See requirements below Follow the display instructions C2 Start the Wireless Setup WizardInsert the correct CD Install software on additional computers TroubleshootingGo to back of the guide to make a test copy Network Troubleshooting Q5861-90277 Make a test copy

Related manuals

Manual 1 pages 19.21 Kb