HP Gigabit Ethernet and 100Base-T Cards A7012A PCI-X Copper-based 2-Port Gigabit Ethernet Card

Page 11

HP-UX Installation

Network Card Configuration Worksheet

Figure 1-2 A7012A PCI-X Copper-based 2-Port Gigabit Ethernet Card

PCI-X

Dual-Port

1000Base-T

Port B

Activity/Link LEDs

}

RJ-45 Connectors

Flashing = Data traffic

Solid

= Active link

Port A

Speed LEDs

Off =

10 Mbit/s

Green =

100 Mbit/s

Yellow = 1000 Mbit/s

Chapter 1

11

Image 11

Contents HP-UX & OpenVMS Networking Legal Notices Contents Contents Access the system card bay Hardware and Software Installation ProcedureConnect the card to the network Install the cardPrepare to install the software Verify the installation Install the latest softwareConfigure the card using SAM Etc/rc.config.d/hpietherconf Optional Step Configure Jumbo Frames SizeEthernet Card Configuration Worksheet Network Card Configuration WorksheetPort B A7012A PCI-X Copper-based 2-Port Gigabit Ethernet Card Network Card Configuration Worksheet Chapter Preparing for Installation OpenVMS InstallationConfigure the Card Using Lancp Installing the AdapterInstalling the Card Boot the SystemOptional Step Defining Jumbo Frame Size Network Card Configuration WorksheetInstalling the Adapter Chapter FCC Statement For U.S.A Card Physical and Environmental SpecificationsVcci Japan PCI Card Only CanadaEMI Australia and New Zealand EMI Statement European Community Laser Safety StatementsA7011A & A7012A Declaration of Conformance